Multiple choice answers (2 Viewers)

[00iCon]

thats where i went wrong
i thought the force was down because that where its moving =S ahwell

NONNONONONONONONONONOMNONONONONONOJNONONONO!!!!
Force is the force that pushes it through the field, not the induced force!!!!
That being said, the same rule applies to a current carrying conductor in a B field...

 

[untouchablecuz]

Did I really get 15/15?
awesome!

9 cannot be C

use your left hand because your dealing with electrons

 

[Ostentatious]

NONNONONONONONONONONOMNONONONONONOJNONONONO!!!!
Force is the force that pushes it through the field, not the induced force!!!!
That being said, the same rule applies to a current carrying conductor in a B field...

What is the Force then? This was one of my stumpers.

 

[tanuwidge]

Nope, carefully look at the direction of the current between A and B.

Draw the direction.

Now draw the direction of the magnetic field lines (N to S)

You'll see they're always perpendicular.

Force changes with time so it can't be b.....

 

[kieranjackson91]

Did I really get 15/15?
awesome!

sorry to pop your bubble but it's pretty much decided that 9. is A. and you said 9 is C? If you think about it using lenz's law, you said current goes to P right? but that means the field created by this new current will cancel out with the current field BELOW the conductor, thus increasing the speed of the conductor down the page which goes against the law of conservation of energy.

11 is D

sin0=0 so force is minimum
as theta increases, force increases it is not constant till 90 degrees
sin90=1 so force is maximum

cos0=1 so initially torque is maximum
cos90=0 so torque is minimum

so its D

QED

read previous posts- angle is always 90 since its the angle between the conductor AB and the field lines from N to S which is always 90. It is force on AB, reason force is a straight line is because angle is always 90. torque however, approaches 0 as AB reaches the top. torques is the turning force around the axis so is always positive since the motor is always turning in one direction. so not QED. its qeB lol

 

[tanuwidge]

Nope, carefully look at the direction of the current between A and B.

Draw the direction.

Now draw the direction of the magnetic field lines (N to S)

You'll see they're always perpendicular.

Force changes with time so it can't be b.....and it's not based on the current. It's based on the coil itself which is initially parallel to the field so theta=0 . Therefore initial force is 0

 

[00iCon]

9 cannot be C

use your left hand because your dealing with electrons

I just think: electron flow is opposite to conventional current... every time. But the force's direction is the problem i have... maybe 14/15?

 

[williamcarr1991]

ok, i got caddcacccdddaca
was q3 c or d?
they still mean the same thing to me

 

[Ostentatious]

Force changes with time so it can't be b.....and it's not based on the current. It's based on the coil itself which is initially parallel to the field so theta=0 . Therefore initial force is 0

But if you look carefully at the question it says force F on WIRE AB, so that's how you have to go about it.

 

[kieranjackson91]

Force changes with time so it can't be b.....and it's not based on the current. It's based on the coil itself which is initially parallel to the field so theta=0 . Therefore initial force is 0

question clearly says 'force F on wire AB' not coil. torque however is 'the torque T on the rotor'

 

[GT03]

9 cannot be c

use your left hand because your dealing with electrons

+1

 

[Macdwg]

9 cannot be C

use your left hand because your dealing with electrons

Actually i have a feeling that it is C.

If you use the right hand palm rule and point your palm in the direction of the velocity which is down the page, then point your fingers in as the mag field is going into the page, then the thumb gives the direction of the flow of HOLES known as conventional current. Thus the electrons move in the opposite direction and congregate at R.

Although debate it! I might be wrong because it could be eddy currents?

 

[00iCon]

ok, i got
was q3 c or d?
they still mean the same thing to me

i hate it with this NEGATIVE E_P

 

[tanuwidge]

Wait sorry I realise now it's b

FML...12/15

 

[Ostentatious]

For Future Reference:

 

[NitroBoon]

1 C
2 A
3 C
4 D
5 C
6 A
7 C
8 C
9 C
10 B
11 D <- wrong
12 D
13 B
14 C
15 A

oh well 14/15 aint bad

 

[youngminii]

It's A lol

 

[GT03]

Actually i have a feeling that it is C.

If you use the right hand palm rule and point your palm in the direction of the velocity which is down the page, then point your fingers in as the mag field is going into the page, then the thumb gives the direction of the flow of HOLES known as conventional current. Thus the electrons move in the opposite direction and congregate at R.

Although debate it! I might be wrong because it could be eddy currents?

i think its eddy currents. because the conductor moves in the magnetic field, it experiences changing flux. so the current generated produces a force that OPPOSES the motion by lenz's and hence ur palm points UP. thus electrons are at P by right hand rule. anyone agree?

 

[JAM91]

wow i made some stupid fucking mistakes

also q2 according to all text books man has made centripetal force is 9.8 m/s towards the earth

question 4 is D due to the vx component (how the hell else would it have gone further)

question 5 i have no idea i naturally assumed since the moon orbits around the earth the sun would still have no impact at all considering the moon is in line with the sun every day and it plays no effect on it to my understanding....

9 i thought was C because according to the right hand principal the current would be induced towards the P side (THE CURRENT IS POSITIVE) thus the electrons would all head over to the R side

15 is B because an electric field goes from + to - and thus the work done to put the particle in position P is the greatest

feel free to argue

 

[6tgyuio]

can i ask the reason for question 4? I spent half an hour checking the maths with it and im not sure if its a or d. if v=u+at, for vertical u=0, meaning t=v/a. since d said arrive at same time but different velocities, could it be not true since at the same instant time velocities would have to be the same? that said for horizontal x=ut, so i guessed smaller time meant less distance...